The foam insulation is sprayed in, at a minimum coverage of 25mm in thickness, which is a fairly modern technique for boats and will help to retain the heat.
 |
 |
 |
 |
Wednesday, 5 October 2016
The Heat
As we edge closer to moving the boat down south, it is going through the final stages of the build - as far as XR&D are concerned. The pictures show the control panel for the BETA Engine, the internal battening and foam insulation. We also decided to insulate our water tank, which should minimise the condensation that usually drips down the side of these stainless steel tanks.
The foam insulation is sprayed in, at a minimum coverage of 25mm in thickness, which is a fairly modern technique for boats and will help to retain the heat.
The foam insulation is sprayed in, at a minimum coverage of 25mm in thickness, which is a fairly modern technique for boats and will help to retain the heat.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment